swapping from 2x4 to 4x4 - The 1947 - Present Chevrolet & GMC Truck Message Board Network

mjetie71 · 06-30-2010, 07:44 PM

Help! I have a 1972 Suburban 1/2 ton two wheel drive with a 402 cu. in. and turbo 400. I also have a 1968 GMC K10 sitting on a 1973 4x4 frame (home made mounts) I would like to 4x4 the 72 suburban with the brackets and axles off of the 68 I am told the two wheel drive frame and 4 wheel drive frame are the same and all the holes are already in place and that I just have to remove the brackets and bolt them onto the two wheel drive frame (after removing ALL of the two wheel drive equiptment Thank you for any help

06-30-2010, 07:44 PM	#1
mjetie71 Registered User Join Date: Jun 2010 Location: ASlamogordo, New Mexico Posts: 3	swapping from 2x4 to 4x4 Help! I have a 1972 Suburban 1/2 ton two wheel drive with a 402 cu. in. and turbo 400. I also have a 1968 GMC K10 sitting on a 1973 4x4 frame (home made mounts) I would like to 4x4 the 72 suburban with the brackets and axles off of the 68 I am told the two wheel drive frame and 4 wheel drive frame are the same and all the holes are already in place and that I just have to remove the brackets and bolt them onto the two wheel drive frame (after removing ALL of the two wheel drive equiptment Thank you for any help Last edited by mjetie71; 06-30-2010 at 07:45 PM. Reason: fixed a misspelling

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.