Please help, I am in need of an experts opinion, I am converting my 66 Chevy c10 with a newer model power steering box and I have measured and set it up like it should go but my question is this, they sell the power steering adapter plate that can be added to fit the power steering holes but that will push my power steering box about half an inch out to the right and the steering shaft will be off to the right about half an inch now, will this matter? if it does then I would have to notch the frame in the center of the adapter plate so that it goes in the half inch needed for the steering shaft to be straight, but the only reason I’m asking is cause I see a lot of people who use the plates but I do not see that they notch the frame at all. Please Help I want to make sure I’m doing this right so that I won’t screw it up. Thank you in advance for your response. It should end up about where the red line i drew on second pic.
09-12-2010, 07:16 PM
Threaded Mode