Filler Ideas for Blazer Tank? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Boyd · 10-04-2010, 05:26 PM

With the steel blazer tank I got from CPP installed, there is no room between the filler neck and the bottom of the bed floor. There is only about 2" between the frame and bed floor and the filler sticks up about that same amount. I was hoping to attach a filler cap just under the floor and use a billet gas door mounted flush on the top side, but not sure that's possible now without a lot of tedious cutting and welding.

I'd like to see some ideas on how others tackled it. Btw, mine is a stepper.

10-04-2010, 05:26 PM	#1
Boyd Resident Lurker Join Date: Apr 2005 Location: Forney, TX Posts: 205	Filler Ideas for Blazer Tank? With the steel blazer tank I got from CPP installed, there is no room between the filler neck and the bottom of the bed floor. There is only about 2" between the frame and bed floor and the filler sticks up about that same amount. I was hoping to attach a filler cap just under the floor and use a billet gas door mounted flush on the top side, but not sure that's possible now without a lot of tedious cutting and welding. I'd like to see some ideas on how others tackled it. Btw, mine is a stepper. __________________ The Rotten Mule: '72 Chevy Short Step Project- http://67-72chevytrucks.com/vboard/s...d.php?t=417252 "Every normal man must be tempted at times to spit on his hands, hoist the black flag, and begin to slit throats."- H.L. Mencken

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.