Project 55 on 77 frame...

[oneclick]

still have to notch and weld in the drivers mount... i think i walked a mile around this truck with all the measuring i had to constantly do! LOL... going back and forth from pass to drivers side, and back again... tons of measuring!

This is where i stopped last night, still need to weld in the drivers side, then i'm going to add an extra support bracket underneath both mounts, then weld the inner/outer mount together then cap off the tops... then i can start on the rear mounts, then i can actually start putting a structure together for the floor using some box tubing, then i can start making the floor... only problem here is at the moment i only have a few feet of tubing and no sheetmetal, so i will need to get some before i can do much more on the floor...

and... the trigger button on my welder broke, well not the button itself, but the wire came unsoldered inside the trigger, so i have to take the handle apart and solder it back together before i can do anymore welding... always one thing or another that happens...

Jason