IFS question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

kgmunro · 12-15-2010, 07:22 AM

Does anyone know if the ifs crossmember kits will work with a 55-57 1 ton frame? It seems the frame is taller in the rear where the flat deck was but tapers smaller under the cab and towards the front. I would like to use it if possible but am not sure about the compatability of the kit to the frame. Can some one measure the height and the width of the frame where the ifs would weld in so I can see if it is possible to do this??

12-15-2010, 07:22 AM	#1
kgmunro Registered User Join Date: May 2009 Location: Brandon Manitoba Canada Posts: 342	IFS question Does anyone know if the ifs crossmember kits will work with a 55-57 1 ton frame? It seems the frame is taller in the rear where the flat deck was but tapers smaller under the cab and towards the front. I would like to use it if possible but am not sure about the compatability of the kit to the frame. Can some one measure the height and the width of the frame where the ifs would weld in so I can see if it is possible to do this??

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.