|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
12-22-2010, 04:09 PM
|
#1 |
|
Registered User
Join Date: Jul 2003
Location: Cypress, Tx
Posts: 4,005
|
Need some measurements please.
Okay, so I'm trying to figure out how to make something work on my '72 burb. Any help would greatly be appreciated!
For the second row I need the measurements for the distance between where the bracket ( u shaped bracket that holds the seat back in place) on the side of the seat back mounts and the side of the interior cargo panel. I'm trying to see if I can use that setup on my seat, but I'm not sure my seat is as wide as the square body burb second row seat. Also can I get the height of the second row flip seat bracket from the floor to where it mounts on the seat bottom? One last measurement. The distance between the second row leading edge and the back of the front seat. Thanks in advance, I appreciate it. I know it can be a pain. Shawn Posted via Mobile Device
__________________
1972 C20 Suburban- Big Blue Betty '56 Chevy Bel Air Sedan- Frame up Restoration -What would you attempt to achieve if you knew you could not fail?- -I Refuse To Tiptoe Through Life, Only To Arrive Safely At Death's Door- R.I.P. EAST SIDE LOW LIFE |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode