|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
01-11-2011, 12:08 PM
|
#1 |
|
Registered User
Join Date: Jan 2011
Location: Nashville TN
Posts: 3
|
Need Help Removing 1959 Master Cylinder
What is the proper procedure for removing the pedal hinge pin from a 1959 Chevrolet Apache 3/4 ton truck master cylinder? It is quite rusty and is in a remote area (must be done on a jack). After removing the retainer fork, there are two small flats on the end with the Alemite fitting. Does that mean that the pin is threaded? Truck is super rusty and using a hammer is going to be hard.
Clearance between frame and master is close. Thanks in Advance ! |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode