Trouble with windshield install. Question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

*mrhino* · 01-15-2011, 06:52 PM

Im installing my new windshield today. I read on the fourm how easy it is and how it just slides right in. I even followed GMCPauls instructions. my question is: After getting the windshield in (so I think) the bottom keeps poping out when pressure is released. I can get the rubber to go over the flange all the way around, but then it will pop back out. Iv tried 8-10 times dry and with lube. Any ideas as to why it wont seat all the way and stay? Thanks

01-15-2011, 06:52 PM	#1
mrhino Account Suspended Join Date: Aug 2007 Location: USA Posts: 1,223	Trouble with windshield install. Question Im installing my new windshield today. I read on the fourm how easy it is and how it just slides right in. I even followed GMCPauls instructions. my question is: After getting the windshield in (so I think) the bottom keeps poping out when pressure is released. I can get the rubber to go over the flange all the way around, but then it will pop back out. Iv tried 8-10 times dry and with lube. Any ideas as to why it wont seat all the way and stay? Thanks Attached Images Last edited by mrhino; 01-15-2011 at 06:55 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.