Aminum intakes for sale

[crossy]

ALL manifolds listed are Aluminum and used . All are Dual plane design, I do not sell junk. Even if I heli-coil something I guarantee that it is done right . I can take a GOOD pic of any of these..all small block ones are for PRE-1987 heads. Prices DO NOT include shipping. the small block intakes weigh about 20 Lbs. properly boxed and I am in N.J. @ 08070 zip. I can figure shipping with your zip code. I accept paypal if you add 3% to price. Also accept money orders. PLEASE EMAIL ME PERSONALLY at all4trux@snip.net and be specific in the subject box. thanx, DAVE

1.)= $140 ,SBC, Edelbrock Performer #2101 , Finish is Jethot coated inside & out. on a 1-10 scale the jethot is still an 8, very clean , No pitting, If it gets tarnished looking it shines back up with 'neverdull '. Jethot is impervious to antifreeze corrosion attack. this manifold will look good for a long time. I want less than it cost just to get it coated.
2.)=$69, SBC, Holley Contender #300-38, Finish is sandblasted clean,clear coated.comparable to Edelbrock performer, I think this is better for trucks with stock engine. has ridges in floor to break up fuel puddling. No pitting from corrosion. heater hose nipple included.

3.)= SOLD.

4.)= $99,SBC, Edelbrock Performer EGR #3701 ,Finish is bead blasted and clear coated, new condition. this is for the guys that want an aftermarket manifold but have state laws to contend with. There is a block off plate on the EGR hole now, so you can use it that way until you need to pass inspection. hose nipple installed.

5.)=$99,SBC, ZZ4 GM bowtie #10185063 EGR ,about equal to a performer RPM in design but has EGR hole. ,Finish is factory and then was wire wheeled for a little shine. I can sandblast it for $10 extra. , new condition. this is for the guys that want a performence aftermarket manifold but have state laws to contend with. There is a block off plate on the EGR hole now, so you can use it that way until you need to pass inspection.

6.)=$79,SBC,Weiand Stealth #8016, Finish is bead blasted then clear coated. Holley square flange, This manifold is equal to a Performer RPM, No pitting.

7.)=SOLD$.

8.)=$99 , SBC, Edelbrock C4B , finish is clean but sprayed with Aluminum paint ??. I can sandblast this for $10 extra. This old school manifold has the provision for oil tube hole in the front for older engines. This was pretty much Edelbrocks original Mid to upper rpm street manifold that is designed like the old original Z28 intake.Has Holley square flange bolt pattern. very minor pitting,great shape for a 30 year old intake.These were great then and still are now.

9.)=$115 , Big Block Chevy BBC, Edelbrock performer 2-0 for oval port heads. Finish is bead blasted and clear coated. looks better than new.No pitting,