The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > General Truck Forums > Suspension

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 02-26-2011, 04:32 PM   #1
ItsRandy
Registered User
 
ItsRandy's Avatar
 
Join Date: Nov 2010
Location: Grand Terrace, Ca.
Posts: 1,607
Pinion angle\2 piece driveline question

I'm getting ready to set the pinion angel on my coil spring 69 1\2 ton long bed. I have information that you set the pinion angle just as you would if you were working on a single piece driveline (pinion 3* above horizontal, crank\out put shaft 3* below horizontal)...does anyone know, is this true? Location of the carrier bearing doesn't come into play?
ItsRandy is offline   Reply With Quote
 

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 06:38 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com