The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > General Truck Forums > All 4x4 Tech & Off Roading

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 03-02-2011, 10:15 PM   #1
barrolde
Registered User
 
barrolde's Avatar
 
Join Date: Feb 2011
Location: calgary, ab
Posts: 35
chewed up dana 44 front

Was not happy to pull my front diff cover and see this! I was almost done all the work I had planned too.

Obvious question is - is this normal wear and tear or abuse or a bad setup? The fluid was dirty but not low. I'd like to determine a potential cause so I know how to proceed, i dont want to just put another dana 44 in there if something is wrong w/ the setup and this will only happen again.

This is an open knuckle dana 44 right? but I'm not sure of the gearing yet, will count now. It is 4.10 on the 14 bolt cop rear diff.

Its passenger drop from my np205 and is turning 37" procomp's

The knuckle on the driver side axle reads 4358, the inner axle says spicer. The main diff gear reads 1 23 79 dana d 18520 b3r19 05-11

I guess I need to completely figure out what I have and then what to do... any suggestions?
Attached Images
     
__________________
Life is a garden.. can you dig it?
barrolde is offline   Reply With Quote
 

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 10:13 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com