62allenhead new with a 62 03-05-2011, 11:23 AM
Bugeyev8 Re: new with a 62 03-05-2011, 11:30 AM
Captainfab Re: new with a 62 03-06-2011, 12:56 AM
markeb01 Re: new with a 62 03-06-2011, 01:21 AM
scotts62 Re: new with a 62 03-06-2011, 11:08 AM
62allenhead Re: new with a 62 03-06-2011, 11:25 AM
62allenhead Re: new with a 62 03-06-2011, 11:21 AM
Rannos Re: new with a 62 03-06-2011, 09:12 PM
62allenhead Re: new with a 62 03-06-2011, 09:59 PM
1Bad62Pro/Street Re: new with a 62 03-06-2011, 11:43 PM
62 Longbed Re: new with a 62 03-06-2011, 05:39 PM
awbrown Re: new with a 62 03-06-2011, 08:19 PM
62allenhead Re: new with a 62 03-19-2011, 11:13 AM
Captainfab Re: new with a 62 03-20-2011, 01:03 AM
Lolyin58 Re: new with a 62 03-20-2011, 06:59 AM
62allenhead Re: new with a 62 06-08-2011, 06:24 PM
awbrown Re: new with a 62 06-08-2011, 07:37 PM
62allenhead Re: new with a 62 06-08-2011, 07:48 PM
mikesC10 Re: new with a 62 06-09-2011, 12:34 AM
kieth Re: new with a 62 06-10-2011, 02:32 PM
62allenhead Re: new with a 62 06-13-2011, 10:00 PM
eurospec1 Re: new with a 62 06-10-2011, 02:49 PM
LakeShow24 Re: new with a 62 06-11-2011, 08:50 PM
62allenhead Re: new with a 62 06-13-2011, 09:59 PM
|
03-05-2011, 11:23 AM | #1 |
Registered User
Join Date: Mar 2011
Location: sparta,mi
Posts: 9
|
new with a 62
Hey guys, new to the forum. I just picked up a pretty solid 62. Its just primer white right now. It has a 350 and a turbo 400 trans. I was able to drive it home but quickly found out it had bigger tranny issues than I had thought. I was told it just needed a rear seal, but now once it warms up it poors fluid out the front seal so I found another trans to throw in it. Anyway heres a pic of it..sorry its the only one I got right now.
I had a few questions too. How low can I go with a static drop and no c notch? Also the timing is off. It has a 350 with an hei distributor. I can't turn the ditributor anymore because the vacuum advance hits the firewall on the passenger side. Do I just need to lift the distributor out and turn it counter clockwise one tooth and drop it back in? Do I make sure the rotor is pointing in the same direction or does it need to turn with the distributor? |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|