![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Mar 2011
Location: Joplin, MO
Posts: 161
|
Lock-Up Torque Converter Question
Alright guys and gals...I'm gonna keep this short and sweet. I have a tendency to be long winded so here goes.....
1984 GMC Sierra Classic 305/TH350C SWB 2.73 gears (Not 3.73) So the other day, my truck started acting up at idle and I found a fuel leak from the carb to the manifold. I removed the stock Q-Jet, got a rebuild kit and float and took the carb to a reputable Q-Jet mechanic to have it rebuilt. I got it back the next day and my truck ran great. Well yesterday, all of the sudden, my truck started acting up again and I noticed another fuel leak in the same spot. So I removed the carb and took it back to the mechanic. He said there was a little trash in it and he needed lower the float level. I replaced the fuel filter in the carb and added a 3/8" inline as well. The sending unit and strainer are new as well. I put the carb back on my truck and it is running great again. Here is the problem, my lock-up torque converter is no longer locking up. I did notice that I broke off one of the small nipples that runs from the temp switch that screws into the thermostat housing. So I very carefully put some epoxy on the nipple so I could properly hook back up the vacuum line that goes to it. It is the top nipple and is one of five that go to it. I held the nipple in place as I put epoxy around it it so as to not get epoxy inside the nipple and prevent it from working properly. I double checked all vacuum lines to the carb and inspected all of the "t's" and check valves. Everything appears to be hooked up correctly and I see no problems or other breaks in the lines. Anyone have any ideas of what I could have missed or messed up to keep the lock-up from working? I have done a search and come across a few threads with some info. Nothing real definitive though. I am 100% sure it is a lock-up TH350. Before the last carb R&R, and when driving down the road at 55 or so, I could lightly tap the breaks and the lock-up would disengage, so I know it works. It is only after the carb R&R that it has stopped working. The vacuum line that ran to the nipple, that I had to reattach, "t's" off in 2 places and one of the vacuum lines runs to a switch mounted to the firewall directly behind the passenger side valve cover. This vacuum line attaches to the switch and the switch has two wires running from it to somewhere. I know the converter locks up via an electrical signal, but what sends that signal to the trans? If it were RPM signal (which I don't see how it could be), I would think there would be a wire attached to the tach side of the HEI distributor that runs or connects to the trans. Maybe it is a vacuum signal to the above mentioned switch that gets signal from the thermostat housing vacuum port and that switch sends an electrical signal to the trans that in turns activates the lock-up switch on the trans? I'll keep doing some searching but would appreciate any info or input you all might have for me. Looks like my attempts not to be long winded failed. Thanks!
__________________
Jeremy I have done so much, for so long, with so little, I can do anything with nothing! 1984 GMC Sierra Classic-1/2 ton-SWB (R.I.P.) 1986 GMC Suburban 3/4 ton 4x4 2014 GMC Sierra LTZ Z-71 Crew SWB |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|