two piece drive shaft - The 1947 - Present Chevrolet & GMC Truck Message Board Network

C10bomber · 04-12-2011, 11:34 PM

Hey need some help here, i have a 1969 C10 and i want to keep it a longbed truck, but heres my problem i don't know if the two piece drive shaft will hold up to my motor. Its a 383 stroker with TH350 trans.I just have the short block with forged internals for now. So before i continue the build i need some advice on what to do with the drive shaft setup as i can see it will be my weakest link. I'm aiming on my engine build for 450+HP and torque numbers. and maybe a little touch of the fast juice.

04-12-2011, 11:34 PM	#1
C10bomber Registered User Join Date: Apr 2011 Location: Los Angeles, CA Posts: 6	two piece drive shaft Hey need some help here, i have a 1969 C10 and i want to keep it a longbed truck, but heres my problem i don't know if the two piece drive shaft will hold up to my motor. Its a 383 stroker with TH350 trans.I just have the short block with forged internals for now. So before i continue the build i need some advice on what to do with the drive shaft setup as i can see it will be my weakest link. I'm aiming on my engine build for 450+HP and torque numbers. and maybe a little touch of the fast juice.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.