|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
06-03-2011, 11:30 PM
|
#1 |
|
Registered User
Join Date: Apr 2009
Location: Centreville, Virginia
Posts: 846
|
Transmission crossmember interchangibility
What year transmission crossmembers are interchangable? I threw my old one from my 82' out because of the PO's hack job and picked up one from 87' dually burb (off of his 90' Burb).
Tried to put in in tonight and it's not even close to fitting. Any ideas??? Am I going to have to drill some new holes to install the one I got from Chris or get one from another 81'-82'? Can not put the motor and Muncie in with out one. I knew I should have kept that old crossmember!!!!!!!!!!!!!!!!!!! Here is a pic of where the part that mounts to the underside of the top of the frame is mounted. Is this the correct position for a TH350 or a Saginaw 3 spd? What I pulled out of there was a Olds TH200 and the PO had to notch the crossmember for the tranny pan to clear.
__________________
The Fleet........ 68' Camaro - 1st car (restored & still have it) 09' VW Tiguan (Wife's Daily Driver) 14' VW Passat SE TSI (my personal) 14' Ford Edge Sport (Daily Work Vehicle) 73' SWB Stepside - 77K org. miles 74' LWB 454/TH400 - drive train transplant for my (Sold) 98' SWB C1500 W/T - shop truck (Sold) 90' GMC Sierra SLE short step - aka " Jezabelle " (Sold) |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode