TH400 Crossmember placement Question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

ChevLoRay · 06-04-2011, 04:29 PM

You know how when you take stuff apart and you make those "mental" notes about where stuff goes? Yeah, we did that when we stripped the '69 SWB chassis down for sandblasting and painting. So, today we put the crossmember back into the chassis....and the mental notes are gone.

From the center-to-center placement of the holes in the crossmember, we found one good set of holes in the frame that line-up. I don't have a picture, but hopefully I can get one today. The chassis is at my sons' house....

Anybody got an answer or picture that shows what I'm asking about?

06-04-2011, 04:29 PM	#1
ChevLoRay Old Skool Club Join Date: Jun 2001 Location: Benton, AR "The Heart of Arkansas" Posts: 10,880	TH400 Crossmember placement Question You know how when you take stuff apart and you make those "mental" notes about where stuff goes? Yeah, we did that when we stripped the '69 SWB chassis down for sandblasting and painting. So, today we put the crossmember back into the chassis....and the mental notes are gone. From the center-to-center placement of the holes in the crossmember, we found one good set of holes in the frame that line-up. I don't have a picture, but hopefully I can get one today. The chassis is at my sons' house.... Anybody got an answer or picture that shows what I'm asking about? __________________ Member Nr. 2770 '96 GMC Sportside; 4.3/SLT - Daily driven....constantly needs washed. '69 C-10 SWB; 350/TH400 - in limbo The older I get, the better I was.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.