|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
07-19-2011, 04:57 PM
|
#1 |
|
Registered User
Join Date: May 2010
Location: Wallingford, PA
Posts: 186
|
Straightening slightly overbent U bolt - how??
One of the new U bolts for the coil rear on my 70 is slightly overbent on one side. How would I go about straightening it enough so I can get through the pads on the axle (or at least hold it open to get it on)? It's about 1/8"-1/4" bent in too much on one side. It doesn't look like a BFH would do it. I can get pics soon if it would help.
__________________
1970 Chevy LWB - 305/350 In Progress: 4/6 ECE drop, front discs, power brakes, Coys C5's. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode