4l60e Driveshaft question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

knockoutgasser · 07-31-2011, 03:53 AM

My last major hangup before doing my LS swap is the drive shaft. I keep coming across 4L60Es with fixed yokes for a two piece shaft set up. MY 75 LWB is a single piece shaft with a slip yoke

So after much searching before I posted this, it seems I have to do one or two of the following
1. have to find a slip yoke 4L60e
2. Swap tailhousings on the 4L60e i have if available
3. Install a two piece shaft set-up and carrier
4. Get a custom driveshaft made with a slip built in from the Jeep shaft builders ($400)

So are the tailhousings interchangeable on the 4L60e without having to tear into the thing and change output shafts?
Any suggestions guys?

07-31-2011, 03:53 AM	#1
knockoutgasser Registered User Join Date: Jul 2011 Location: Oregon Posts: 7	4l60e Driveshaft question My last major hangup before doing my LS swap is the drive shaft. I keep coming across 4L60Es with fixed yokes for a two piece shaft set up. MY 75 LWB is a single piece shaft with a slip yoke So after much searching before I posted this, it seems I have to do one or two of the following 1. have to find a slip yoke 4L60e 2. Swap tailhousings on the 4L60e i have if available 3. Install a two piece shaft set-up and carrier 4. Get a custom driveshaft made with a slip built in from the Jeep shaft builders ($400) So are the tailhousings interchangeable on the 4L60e without having to tear into the thing and change output shafts? Any suggestions guys?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.