Window Comes Out of Channel - The 1947 - Present Chevrolet & GMC Truck Message Board Network

THE "10" SILVERADO · 09-01-2011, 11:16 PM

Does anyone else have this problem? My windows are fine when you roll them down (you better cause it's burning outside) but when you start to roll them up, they "bump" out of the channel and are a pain trying to get back in.

To get them back in you have to roll them down halfway, and then try to lift/push on them to get them back.

Will replacing the window channel rubber help this at all? LMC carries a kit for both doors for $99...and if I don't have to mess with my windows, then it's well worth it.

09-01-2011, 11:16 PM	#1
THE "10" SILVERADO Registered User Join Date: Sep 2010 Location: Marble Falls, TX Posts: 1,575	Window Comes Out of Channel Does anyone else have this problem? My windows are fine when you roll them down (you better cause it's burning outside) but when you start to roll them up, they "bump" out of the channel and are a pain trying to get back in. To get them back in you have to roll them down halfway, and then try to lift/push on them to get them back. Will replacing the window channel rubber help this at all? LMC carries a kit for both doors for $99...and if I don't have to mess with my windows, then it's well worth it. __________________ Michael Re-starting the neglected '77...http://67-72chevytrucks.com/vboard/s...=425464&page=9

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.