I have been defeated... - The 1947 - Present Chevrolet & GMC Truck Message Board Network

firefighter736 · 09-13-2011, 06:36 PM

At least for today.

I spent the better part of the day trying to line up an aftermarket core radiator support and two inner fenders. I'm this close to losing my religion over this.

The passenger side inner fender is approx 3/4" longer than the orginal. The drivers side is 1/2". Even with this in consideration the radiator support is about 1/2" too far back to mount.

Any tips on where to start/what panel to put on first to make this a little less frustrating?

09-13-2011, 06:36 PM	#1
firefighter736 Registered User Join Date: Aug 2010 Location: Floyd/Salem VA Posts: 148	I have been defeated... At least for today. I spent the better part of the day trying to line up an aftermarket core radiator support and two inner fenders. I'm this close to losing my religion over this. The passenger side inner fender is approx 3/4" longer than the orginal. The drivers side is 1/2". Even with this in consideration the radiator support is about 1/2" too far back to mount. Any tips on where to start/what panel to put on first to make this a little less frustrating?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.