The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1960 - 1966 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 10-15-2011, 11:37 AM   #1
blackdawg
Blackdawg
 
Join Date: Aug 2010
Location: North Delta ,British Columbia
Posts: 213
driveshaft installation

I'M to the point in my build that i will be installing the driveshaft.i bought the truck without a engine and tranny.
so far i have installed a a 350 engine and a th 4oo tranny.
everything to this point has lined up.i didn"t have to move the cross member for the tranny it bolted right up.my question is on the drive shaft.its a one piece and i haven"t measured the lenght yet.will this just bolt in and how far should the spline insert into the tranny.the spline has some surface ruston it should i just clean in up with a scouring pad and wd-40 .And should i grease the spline going in as well as the rear yoke.
blackdawg is offline   Reply With Quote
 

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 04:47 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com