Project No-buck!

[Ackattack]

Pictures!

Here is the new engine in its home



Here is the fuse block I used and the ALDL connector. I won't have a glove box, which is kind of annoying since I just got a new cardboard glove box in Sept. Oh well.



Here is a shot with no air cleaner so you can see the distribution block a little better. Also, the maroon panel is not finished yet. Basically it will be removable so you can get the A/C unit out. I have to make a sheetmetal frame around it that I'll weld to the red panel and then it will screw to the firewall and then seal with some foam weather stripping.




Here is the heater controls. I'm not sure if I'm going to mount it in the radio spot or down in the original location. The little control box is pretty deep, so I'm not sure where I'll have room for it. Or the ashtray (not that I need one), or the radio. I'll figure that out when I get to the diverter box.



Here you can see how much I had to move the firewall out. In addition to this and the cutout area, I also had to trim about an inch off the bottom of the dash.



Like I said in an earlier post, I wouldn't recommend doing this and I'm not even done with it. I still have the diverter box, R-134 retrofit and posibbly the fresh air conversion.