Need brake help ASAP - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Rob68c10 · 04-06-2012, 09:02 PM

My truck is currently on jack stands because I apparently didn't do enough research. I have a 68 that I converted from manual drum to power disc up front. The rubber lines would not connect to the metal lines, and my proportioning valve lines would not connect. I ordered pre bent lines from LMC for a 1972, and they are no where near close at all. Did I get bad parts or is there something that I am missing here? I need to know as soon as possible so I can get this thing out of my buddies garage.

04-06-2012, 09:02 PM	#1
Rob68c10 Registered User Join Date: Mar 2010 Location: Eastern Shore, Maryland Posts: 159	Need brake help ASAP My truck is currently on jack stands because I apparently didn't do enough research. I have a 68 that I converted from manual drum to power disc up front. The rubber lines would not connect to the metal lines, and my proportioning valve lines would not connect. I ordered pre bent lines from LMC for a 1972, and they are no where near close at all. Did I get bad parts or is there something that I am missing here? I need to know as soon as possible so I can get this thing out of my buddies garage.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.