2 for 1, My son's first Square Build

[aggie91]

Did some work on the cab. Since we moved the engine back and up to gain some clearance and not hang below the frame, we set the cab on the frame and cut out the trans hump to clear the 4L60e. We are going to make a custom trans tunnel once we get the seats and all figured out.


I worked last night for a few hours cleaning up and covering the wires in the harnes. I mounted the PCM and a relay/use block to a piece of aluminum that will be mounted in the cab under the dash. I still have about an hour of taping and misc clean up on the harness, but it is done for the most part till we get the rest of the wiring for the truck. The wires with the blue and green tape are things like Tow Haul mode switch, Vehicle speed output, Tack out put, etc...The red wire coiled up are the power inputs for the relays and fuses.