Power Steering: Project Swiss Cheese - The 1947 - Present Chevrolet & GMC Truck Message Board Network

biohazardbill · 10-07-2012, 10:23 AM

So today I go in to start taking off the control arms etc to replace them with the 73-87 arms. The PO had done a PS conversion but to clean it up I got a Capt Fab bracket. When I get the steering box off I see the following:

What is the best way to repair this and make it safe?

Side Note: I do have an extra frame (havent got underneath to see how good it is) but not really wanting to do a frame swap if I dont have to.

10-07-2012, 10:23 AM	#1
biohazardbill Registered User Join Date: Jan 2010 Location: Forsyth, Ga Posts: 1,012	Power Steering: Project Swiss Cheese So today I go in to start taking off the control arms etc to replace them with the 73-87 arms. The PO had done a PS conversion but to clean it up I got a Capt Fab bracket. When I get the steering box off I see the following: What is the best way to repair this and make it safe? Side Note: I do have an extra frame (havent got underneath to see how good it is) but not really wanting to do a frame swap if I dont have to.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.