![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#11 |
GEARHEAD
Join Date: Aug 2003
Location: MN
Posts: 6,122
|
Re: Junkyard Jimmy Super Low Buck Build Thread
Got a couple hours in the garage this afternoon. I cleaned up the welds on the door a bit more, found a couple more pinholes to put a spot of weld on and called it good enough. Then pulled out a fender to use for the driver side. One dent that had the metal stretched pretty good got hammered out. It was popping in and out though so I heated it up with the propane torch and quick cooled it with a wet rag. Hammered a bit more and torched it again and it cured the oil canning. Then I spent some time looking it over for rust holes and other damage. Then I spotted some holes drilled in the wheel arch, probably for some kind of flare, so welded those up.
![]() The emblem holes were for a 68 chevy and wouldn't work for the K5 emblems, so I welded those up too. ![]() It was a pretty clean fender and should look good once its stripped of paint and smoothed out with some filler and primer. ![]() Hoping to get primer on both the door and fender tomorrow, but I don't know if I'll get the fender stripped in time. Just have to see how it goes. Because I still have to cut off the cup and weld in the plate for the bumper mod.
__________________
If no one knows what you're doing, they can't tell you you're doing it wrong HG's Dream Car Build - Shelby Cobra Kit Build your own adjustable track bar 71 ![]() 72 ![]() HG's Plow Truck '78 ![]() Bigass Farm Truck HG's thread of miscellaneous stuff |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|