TX 67 Tach cluster, cab divider trim, misc - The 1947 - Present Chevrolet & GMC Truck Message Board Network

hfd410 · 02-23-2013, 06:17 PM

I got this tach cluster out of a 67gmc at the junkyard. The tins and printed circuit look pretty good. The lens has a few scratches but would polish out. I have the harness too. The brown coil wire was cut pretty short but there is enough to get on. I just told you all I know about it. $325 shipped CONUS

cab divider trim- two sets-both have very small imperfections (one or two spots) should polish up nice. $30 each plus shipping

stock height front coils-never ran $40 plus shipping

cigar lighter and filler neck gasket $7 shipped each CONUS

02-23-2013, 06:17 PM	#1
hfd410 Registered User Join Date: Jul 2012 Location: Burleson Texas Posts: 570	67 Tach cluster, cab divider trim, misc I got this tach cluster out of a 67gmc at the junkyard. The tins and printed circuit look pretty good. The lens has a few scratches but would polish out. I have the harness too. The brown coil wire was cut pretty short but there is enough to get on. I just told you all I know about it. $325 shipped CONUS cab divider trim- two sets-both have very small imperfections (one or two spots) should polish up nice. $30 each plus shipping stock height front coils-never ran $40 plus shipping cigar lighter and filler neck gasket $7 shipped each CONUS Attached Images

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.