|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
03-13-2013, 10:28 PM
|
#1 |
|
Registered User
 
Join Date: Jul 2012
Location: Ladysmith, WI
Posts: 641
|
72 C20 Upper Arm shaft question
All right, I'm replacing the shaft in the upper arms on my 72 C20, but I have a question. The new shafts are Moog units. I have one of them centered (I think) and installed in the a-arm, and torqued the bushings in to 90 lb-ft per the Moog instructions. One of the bushings bottomed on the side of the arm and the other bushing is still a ways out (see the pics). Is this OK? Does this mean I somehow don't have the shaft centered?
__________________
Nick Old Mustard, 1972 Chevy C20, 350, TH350, 4.10 Dana 60 rear, owned since I was 16 in 1986 http://67-72chevytrucks.com/vboard/s...d.php?t=545356 Blue Bell, 1987 K20, 6.2L Diesel, TH400/NP208, 4.10 gears Ustahav 1976 K10, 350/350/203, Gov Loc, Yooper beater trail truck. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode