|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
03-29-2013, 02:19 PM
|
#1 |
|
Registered User
Join Date: Nov 2012
Location: santa rosa,california
Posts: 650
|
Unbending Brake Lines Smoothly?
I just got my Inline Tube brake lines in the mail and the two long lines were bent in half so they would fit in the box.The bend is a half circle about 6 inches across and I don't want to kink it unbending it and I would prefer it to come out smoothly.
Any ideas on getting it unbent and still looking halfway decent? Should I just cut out this section and a small length of tubing? If I knew this was what I was getting I would never have bought it. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode