KS LWB K10 Rear Drive Shaft F/S - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**Ironhorse** · 04-20-2013, 06:30 PM

Pulled this from my '71 1/2 ton long bed 4x4 with sm465/np205 set-up. Had to change drive shaft length due to swapping to a 350TH/np205. Ran fine, with a new slip shaft, stub shaft at front end and u-joints, about 3,500 miles since work was done. All work and re-balance was done by PowerDrive 4x4 in Wichita, Ks. A good plug-n-play 1/2 ton long bed 4x4 rear shaft. Measures 59 1/2'' center to center on u-joints. $75 plus shipping, money order only, no Paypal account.

04-20-2013, 06:30 PM	#1
Ironhorse Senior Member Join Date: Jul 2001 Location: Wellington, Ks Posts: 10,294	LWB K10 Rear Drive Shaft F/S Pulled this from my '71 1/2 ton long bed 4x4 with sm465/np205 set-up. Had to change drive shaft length due to swapping to a 350TH/np205. Ran fine, with a new slip shaft, stub shaft at front end and u-joints, about 3,500 miles since work was done. All work and re-balance was done by PowerDrive 4x4 in Wichita, Ks. A good plug-n-play 1/2 ton long bed 4x4 rear shaft. Measures 59 1/2'' center to center on u-joints. $75 plus shipping, money order only, no Paypal account. Attached Images __________________ 1971 Chevy 1/2T 4x4 LWB 350 V-8 Was sm465-now 350TH/np205 Tilt, Tach, Towhooks Original Truck AM/FM Wellington, Ks

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.