switching from old heads to really old heads - need pully advice - The 1947 - Present Chevrolet & GMC Truck Message Board Network

*cranknut67* · 11-19-2003, 03:47 AM

I just got the new heads in casting #3782461 cut for 1.6 2.02 valves ( 3 angle job fully tricked out ), and I noticed that they have no accessory holes. I now need the whole dang setup from an older non head mounted block. and I plan to set up the heads this weekend - anybody in az have a whole setup pullies and all, to sell? I have the power steering bracket - ordered it online tonite. still need the pullies for the water pump crank ( 3 groove I think) and the alternator bracket. - I can allready tell that this is going to be a pain in the butt

confused:

11-19-2003, 03:47 AM	#1
cranknut67 Account Suspended Join Date: Jun 2003 Posts: 139	switching from old heads to really old heads - need pully advice I just got the new heads in casting #3782461 cut for 1.6 2.02 valves ( 3 angle job fully tricked out ), and I noticed that they have no accessory holes. I now need the whole dang setup from an older non head mounted block. and I plan to set up the heads this weekend - anybody in az have a whole setup pullies and all, to sell? I have the power steering bracket - ordered it online tonite. still need the pullies for the water pump crank ( 3 groove I think) and the alternator bracket. - I can allready tell that this is going to be a pain in the buttconfused:

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.