OT IH Scout, steel gasket??? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

walker · 11-20-2003, 09:23 PM

I have a '67 Scout with the 196 slant 4. I pulled the head due to crack and am in the process of putting it back together. The gaskets that came for it, marked IH on the box and are the same as the old ones, are stamped steel. The head gasket is composite, but the intake/exhaust gaskets are steel. When I put these on do I need to put a sealer around the intake ports and water jackets, or do I put them on bare?
I have never used shim type gaskets before and don't want to have intake leaks. Thanks.

11-20-2003, 09:23 PM	#1
walker Registered User Join Date: Jul 2003 Location: north of Phx AZ about 30 miles Posts: 698	OT IH Scout, steel gasket??? I have a '67 Scout with the 196 slant 4. I pulled the head due to crack and am in the process of putting it back together. The gaskets that came for it, marked IH on the box and are the same as the old ones, are stamped steel. The head gasket is composite, but the intake/exhaust gaskets are steel. When I put these on do I need to put a sealer around the intake ports and water jackets, or do I put them on bare? I have never used shim type gaskets before and don't want to have intake leaks. Thanks. __________________ Andy,Phx AZ '67 C-10 (Ahhh, done at last. Well there is that disk front end I want to put in and...) "23 C-Cab-sold '48 Ford 8N tractor(still working) '67 Scout(Now on the road) '70 MG B.-sold

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.