What would you use from an IROC - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Fesser · 06-10-2013, 12:26 PM

If all goes well I will soon be getting another project, a 70 C10 SWB fleetside. It's pretty rough and the engine and trans are dismantled. I have an 86 IROC that has been sinking into the ground next to my barn for a few years. Was running when parked.

I am leaning toward using the TPI 307 and 200 4R in the C10. Then I started wondering what else might be useful on the truck. I only have been toying with the idea, haven't measured anything or dismantled anything yet.

If you could take anything you wanted from an Iroc to use on a C10, what would you use?

06-10-2013, 12:26 PM	#1
Fesser Registered User Join Date: Feb 2010 Location: Napa, CA Posts: 519	What would you use from an IROC If all goes well I will soon be getting another project, a 70 C10 SWB fleetside. It's pretty rough and the engine and trans are dismantled. I have an 86 IROC that has been sinking into the ground next to my barn for a few years. Was running when parked. I am leaning toward using the TPI 307 and 200 4R in the C10. Then I started wondering what else might be useful on the truck. I only have been toying with the idea, haven't measured anything or dismantled anything yet. If you could take anything you wanted from an Iroc to use on a C10, what would you use?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.