How do the rubber cab mounts go? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**1971Stepside** · 11-29-2003, 11:41 PM

Lost Wages gave me a set of radiator support and cab mounts (rubber) but I can't figure out what goes where.

I have the radiator support figured out I believe. It uses a smaller diameter rubber and has flat rubber (rather than coned) pieces for the bottom.

On the cab I have two different thickness rubber pads. Do the thicker ones go in the front or the back of the cab? All four have the coned pieces for the bottoms.

I would like to set the cab back on the frame tomorrow, but I need to know how these go first. Any help would be greatly appreciated.

11-29-2003, 11:41 PM	#1
1971Stepside Almost Satisfied Join Date: Mar 2002 Location: Springfield, MO Posts: 2,932	How do the rubber cab mounts go? Lost Wages gave me a set of radiator support and cab mounts (rubber) but I can't figure out what goes where. I have the radiator support figured out I believe. It uses a smaller diameter rubber and has flat rubber (rather than coned) pieces for the bottom. On the cab I have two different thickness rubber pads. Do the thicker ones go in the front or the back of the cab? All four have the coned pieces for the bottoms. I would like to set the cab back on the frame tomorrow, but I need to know how these go first. Any help would be greatly appreciated. __________________ 1971 C10 Stepside. LSx 6.0 with BTR Stage IV, Speed Engineering Headers, 4L80e transmission w/3200 Circle-D Stall. 3.73. Posi. Purchased this truck when I was 17. I started the rebuild (or take apart) in 1993. I have drug it around all over the country in pieces. Finally back on the road in 2021. "I can't complain, but sometimes I still do. Life's been good to me so far."

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.