|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
07-27-2013, 09:52 AM
|
#1 |
|
Registered User
 
Join Date: Aug 2011
Location: Kingman, AZ
Posts: 1,574
|
One more rear axel bearing question?
I didn't have a bearing puller so I used a long steel rod to push the old bearings and seals out from the inside of my '64.
Since I was on the opposite side of the truck I did not get to see the order in which these 3 parts came out of the housing. I think the large flat metal washer goes in 1st, then the bearings and then the seal? Is that correct or no?
__________________
http://s994.photobucket.com/albums/af62/ScottAz2/ |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode