Stock bumper height front and rear of 64 chev shortbed - The 1947 - Present Chevrolet & GMC Truck Message Board Network

truckeroy · 01-09-2014, 02:06 PM

My 64 stepside shortbed had the front and rear springs cut by the PO. It looks good, but cutting the pigtail off the bottom of the rear springs was not smart. They took some steel bars to bolt accross the bottom coil of the spring. The front ones are just too low. I can't find the factory dimensions for the stock bumper heights in my books or on this site. Can anyone give me a close dimension front and rear so I know where to start? I want to have a modest lowered stance, but also want the tires I put under it to fill in the wheelwells. Thanks, Roy

01-09-2014, 02:06 PM	#1
truckeroy Registered User Join Date: Oct 2013 Location: Shelbyville, IL Posts: 111	Stock bumper height front and rear of 64 chev shortbed My 64 stepside shortbed had the front and rear springs cut by the PO. It looks good, but cutting the pigtail off the bottom of the rear springs was not smart. They took some steel bars to bolt accross the bottom coil of the spring. The front ones are just too low. I can't find the factory dimensions for the stock bumper heights in my books or on this site. Can anyone give me a close dimension front and rear so I know where to start? I want to have a modest lowered stance, but also want the tires I put under it to fill in the wheelwells. Thanks, Roy __________________ 1948 Chevy 1/2T 1964 Chevy 1/2T stepside short bed 1939 Pontiac coupe Street Rod 2005 GMC 1/2T short bed

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.