Swapped Intakes Now Trucks isnt Running Right - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**DreamRyder1963** · 01-21-2014, 02:33 PM

I swapped the offenhauser 360 degree intake on my truck for a Edelbrock Performer EPS. The truck still runs but just barely. I have had tho advance the distributor well past where it was for the 360 intake. When you try to take off the truck bogs down and tries to stall. If you keep the rpms up you can take off but it shutters and jerks all the way through the gears. I think is also running rich. I starting to think that the jets are not stock in the carb (its a Holley 600). Anything else I'm missing?

01-21-2014, 02:33 PM	#1
DreamRyder1963 Senior Member Join Date: Jul 2012 Location: Knoxville, TN Posts: 499	Swapped Intakes Now Trucks isnt Running Right I swapped the offenhauser 360 degree intake on my truck for a Edelbrock Performer EPS. The truck still runs but just barely. I have had tho advance the distributor well past where it was for the 360 intake. When you try to take off the truck bogs down and tries to stall. If you keep the rpms up you can take off but it shutters and jerks all the way through the gears. I think is also running rich. I starting to think that the jets are not stock in the carb (its a Holley 600). Anything else I'm missing? __________________ 1971 Chevy C10 Cheyenne (sold for Mazda) 1963 Chevy Corvair Pro-Touring Project 2012 Mazda 3 i Sport sedan http://www.dracoautodesigns.com/

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.