|
|
|
|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
02-17-2014, 09:42 PM
|
#11 |
|
Senior Member
Join Date: Apr 2004
Location: sw colorado
Posts: 2,720
|
Re: Making an engine stand, the overkill way
back at it today!
it fits! really well. about 2 thou clearance and the bushings were concentric!  the big end. the mounting plate will be here one day  its not really a DIY project without a little blood letting... i didnt break the edge of the larger end and when it slid home, my thumb was in the way. Doh  then i dug this bad boy out of the pile. its the inside of a flange we jetted. 1.5" plate and about 12" diameter now. i will be making it all pretty as well as cutting a bore for a press fit on the shaft. i know the the chuck is over jawed. itll be ok for no more than it is. 
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Lemield 
Threaded Mode