|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
10-09-2014, 11:43 AM
|
#1 |
|
Registered User
Join Date: May 2011
Location: Fort Collins, Colorado
Posts: 95
|
Replacement lower A-Arm shaft holes are different
I'm in the process of rebuilding the front end of 1969 C20 pickup, and as far as I can tell all the current parts are original.
When comparing the new lower A-arm shaft to the old one I noticed that the indexing/alignment holes are different. On the old one the holes are closer the end. Is this an intentional change to increase caster? |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode