door speakers...... I know it's taboo - The 1947 - Present Chevrolet & GMC Truck Message Board Network

no1udknow · 02-09-2015, 12:49 PM

Hey everyone,
I was wondering if anyone make a door panel insert that acts as an enclosure for a speaker. There seems to be plenty of room. If not, I may make one. I think if I were able to mold a bowl like enclosure out of fiberglass and put a 5 1/2 or 6x9 speaker into it, and make it about 1/2 inch bigger than the speaker with a lip to mount the speaker to, then a flange to mount on the door. It would probably be better sounding, and less susceptible to any moisture that gets in the door. Your thoughts?

02-09-2015, 12:49 PM	#1
no1udknow Registered User Join Date: Jan 2014 Location: Sacramento,California Posts: 696	door speakers...... I know it's taboo Hey everyone, I was wondering if anyone make a door panel insert that acts as an enclosure for a speaker. There seems to be plenty of room. If not, I may make one. I think if I were able to mold a bowl like enclosure out of fiberglass and put a 5 1/2 or 6x9 speaker into it, and make it about 1/2 inch bigger than the speaker with a lip to mount the speaker to, then a flange to mount on the door. It would probably be better sounding, and less susceptible to any moisture that gets in the door. Your thoughts? __________________ Built not bought! My dad always tried to convince me HEI was pointless! Welding is a lot like sex, you don't have to be great with the rod as long as you thoroughly prep the surface and your good at grinding My build : 68 C10 Short Bed Conversion

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.