|
02-22-2015, 04:17 PM
|
#1 |
|
Registered User
 Join Date: Feb 2015
Location: ND
Posts: 20
|
C notch dillema
Here is my dilemma. Previous builder c notched the frame in the wrong place, 2.5" too far forward. He also built a ladder bar that is lethal by design.
and shortened the drive shaft. I have a new cantilever, fourlink laying on the shop floor to install. KP setup. I need some way to measure the rear axle to locate it properly so I can correct the c notch, and install the canti setup. Measuring from the front hub is a little suspect as it is terribly aligned. TOE IN like 1-1.5" Suggestions please. IC |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode