Drive shaft spacer question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

danadena1960 · 02-03-2004, 02:18 AM

Has anybody used a 1" drive shaft spacer? What is it used for? How about the 1" transfer case lowering kit? What is it used for?
If anybody has any input on these two subjects, please let me know.
Also, does anybody know if they make a longer peice for the rear drive shaft of a 77 K-20 (1 piece drive shaft, long bed) where the u-joint hooks to the rearend yoke, there is a slined female part (the piece the u-joint is attached to on the drive shaft) that slides up and down a male spline that is attached to the big tube of the drive shaft? Or do I need to just have the drive shaft lengthened?
Thanks,
Dana

02-03-2004, 02:18 AM	#1
danadena1960 Registered User Join Date: Aug 2003 Location: Stockbridge, GA (Suburbs of Atlanta) Posts: 126	Drive shaft spacer question Has anybody used a 1" drive shaft spacer? What is it used for? How about the 1" transfer case lowering kit? What is it used for? If anybody has any input on these two subjects, please let me know. Also, does anybody know if they make a longer peice for the rear drive shaft of a 77 K-20 (1 piece drive shaft, long bed) where the u-joint hooks to the rearend yoke, there is a slined female part (the piece the u-joint is attached to on the drive shaft) that slides up and down a male spline that is attached to the big tube of the drive shaft? Or do I need to just have the drive shaft lengthened? Thanks, Dana __________________ Dana 77 K-20 454 73 SS El Camino 454 68 SS Camaro 327 48 Chevy 216 755 John Deere

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.