KS Parting a 72 BB SWB Chassis (not an original BB Chassis)

[Cash3481]

All,
I've decided to sell my BB Chassis to fund my pending garage build. (this is not an original BB SWB Chassis)
There is a member who was interested in it that I am waiting for an answer if they are getting it. After that answer I will be parting the entire truck in some larger parts.
I rebuilt this chassis 3 years ago and drove it daily as a cleaned up cruiser. At that time I rebuilt the front suspension with all new brakes and shocks (both front and rear) and replaced basically everything in the front suspension.
I removed the body to put it on another project after I rebuilt that frame.
The motor was covered with a very thick tarp since the body was removed and all open holes are covered and ziptied.
The following was replaced at the same time I freshened up the suspension...
New water pump, p/s pump, alt, Stainless Steel P/S lines (from the board) and new gearbox.
It has 72 motor mounts on it as well and the correct 7042208 carb for it as well.
The transmission was rebuilt at that time as well and the truck has 18K miles since the rebuild. The motor does not smoke or have any issues at all.
The brakes are still sealed, working and connected to the master cylinder and the truck will fire with a trigger switch. It has new dual exhaust and there are no leaks on any fluids except the transmission fill tube (seeping) and I will replace that gasket before it sells.
The cab has had the Cab corners and rockers done previously.
Here is the breakdown that I'd like to go with:
Rolling Chassis $750sold
Motor/tranny combo $1500sold
Cab $750Sold
Grill $175
Blue Front end $300
SWB Bed sides $275 and $225
SWB Floor (wavy and a few pits but solid) $300
BB High Hump $90Sold
BB Fan Shroud $90sold
I would possibly breakdown the motor parts later if it doesn't sell complete.
I will not be shipping this as everything is large or heavy.
I can load anything purchased on any trailer you bring.