Heater & Wheel Well Removal - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**KyleSeal** · 05-14-2015, 11:47 PM

So I broke the lower connection to the heater core while trimming the rubber lines. Decided to go ahead and replace it or fix it, not sure yet, but I started to unbolt the housing and realized the bolt underneath is very difficult to get out, so I tried unbolting the wheel well like people suggest, well all bolts came out besides one, and it just turns n turns. What should I do? Is there any way to get it out? Also, what size is the lower bolt to the housing? The one right by the wheel well, very bottom. Are there any tricks to removing?

Thanks.

05-14-2015, 11:47 PM	#1
KyleSeal Senior Member Join Date: Mar 2014 Location: Toano, VA Posts: 893	Heater & Wheel Well Removal So I broke the lower connection to the heater core while trimming the rubber lines. Decided to go ahead and replace it or fix it, not sure yet, but I started to unbolt the housing and realized the bolt underneath is very difficult to get out, so I tried unbolting the wheel well like people suggest, well all bolts came out besides one, and it just turns n turns. What should I do? Is there any way to get it out? Also, what size is the lower bolt to the housing? The one right by the wheel well, very bottom. Are there any tricks to removing? Thanks. __________________ "Sometimes I do serve as a good bad example. Glad to be of service." My Build Thread (1967 C10, lowered, EFI, daily truck): http://67-72chevytrucks.com/vboard/s...d.php?t=830809

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.