Windshield installation

[FlameOut]

I have never installed a windshield in one of these trucks before, and was about to attempt it today, using a new Precision seal, but I'm not sure which side faces out and which faces in. (no stainless trim)

I already had one attempt, but pulling on the rope didn't seem to pull the new gasket over the pinch weld enough and when I got to the top, it wasn't even close to going in

Also, the videos that I watched, one says to install the top of the windshield first, and another says to start with the bottom? Is one way easier/better than the other?

This is the way I have the gasket now. This would be on the inside