Heater box question. - The 1947 - Present Chevrolet & GMC Truck Message Board Network

In The Ten Ring · 10-30-2015, 04:10 PM

I will try and get a pic but my computer isn't downloading anything from my camera.

The heater box has the flap inside and that is held in place by a rivet. If one drills out the rivet to allow the flap to come out for derusting, can it be replaced with a bolt and nut and done easily?

Anyone else drill out the rivet that holds the flap inside the heater box?

*Do I even need to worry about derusting and painting the flap inside the heater box?

10-30-2015, 04:10 PM	#1
In The Ten Ring Registered User Join Date: Jun 2013 Location: West Virginia Posts: 6,427	Heater box question. I will try and get a pic but my computer isn't downloading anything from my camera. The heater box has the flap inside and that is held in place by a rivet. If one drills out the rivet to allow the flap to come out for derusting, can it be replaced with a bolt and nut and done easily? Anyone else drill out the rivet that holds the flap inside the heater box? *Do I even need to worry about derusting and painting the flap inside the heater box?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.