|
02-25-2004, 02:13 PM
|
#1 |
|
Registered User
Join Date: Nov 2003
Location: Wisconsin
Posts: 281
|
Stupid question
I'm trying to find a spot to mount my computer for my fuel injection. The only out of sight spots I can find is directly to the bottom of my dash (would need to drill wholes from the top) or mount to the backside or bottom of the cowl inside the truck (the canal where air flows for the heater and WATER runs off)
Has anyone ever drilled holes there. Is there any way to seal up the wholes well enough to prevent water from leaking inside the cab and more importanly on to my computer? I was thinking of some kind of silicone... Am I asking for problems? Should I just drill some holes in the top of my dash? Or should I just mount it on the kick panel or any other suggestions? Oh yeah, the computer is 10 x 6 x 2 inches. Any ideas? Thanks in advance 
__________________
Tom 1968 C10 LWB. 402 BB, Holley MPI, 700R4. 4wheel Hydroboost Disk Brakes. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode