![]() |
![]() |
#1 |
Registered User
Join Date: Dec 2015
Location: Baytown
Posts: 47
|
3 speed to th350 swap
Hey guys, I think I have all the parts ordered (minus the flexplate) for my 3 speed to th350 swap, and after what feels like weeks of research (probably only a few hours total), I have a few things that I am stumped on.
I will be doing the swap at work, on a lift on a Saturday off, and the truck will have to drive back out the same day, one way or another. I found this article, and decided it was something I HAD to do.. I love the idea and look of it.. http://www.trucktrend.com/how-to/int...er-conversion/ What I am stumped on now, is which flexplate to use.. The truck isn't sitting right here where I can get to it at any time, so I am not sure what starter is on it. I can tell you that it is a 305 from the early 80s.. casting 14010201 which is a 2 piece rear seal, and internally balanced. Thankfully that gets my choices down to 2 flexplates. I am also trying to figure out where/how/which way to get a vacuum source for the transmission.. Do I just run a vacuum line up to the 2 barrel? Finally, neutral safety switch.. as I said above, I am using my original 3 on the tree column, not swapping out columns. What am I supposed to do for the NSS? ground it out? constant hot? I think these are the only things I still have to figure out before the time comes to pull the trigger. *Side note* If there is anyone in Houston who is swapping from auto, and wants 3 on the tree, I am willing to do some trading of columns, etc.
__________________
"Cancer Crusher" build start date 11/29/15 |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|