Need input from sway bar guys please... - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Possmguts · 01-01-2016, 01:27 PM

I posted this in my build http://www.67-72chevytrucks.com/vboa...16#post7430716 thread but since it doesn't get much attention I'm posting here as well...

Trying to get this big 1 1/4" sway bar fitted and ran into a little road block.. clearance between the cradle cross member and the bushing mounts only give me like 2 inches, and there is still no weight from motor and trans on it so that's going to get tighter.... Not sure what to do here. It doesn't leave much room for suspension travel... Any ideas?

Anyone have pics or measurements on how much room you have with your dropped setup?

01-01-2016, 01:27 PM	#1
Possmguts Registered User Join Date: Nov 2014 Location: Columbiana Ohio Posts: 1,210	Need input from sway bar guys please... I posted this in my build http://www.67-72chevytrucks.com/vboa...16#post7430716 thread but since it doesn't get much attention I'm posting here as well... Trying to get this big 1 1/4" sway bar fitted and ran into a little road block.. clearance between the cradle cross member and the bushing mounts only give me like 2 inches, and there is still no weight from motor and trans on it so that's going to get tighter.... Not sure what to do here. It doesn't leave much room for suspension travel... Any ideas? Anyone have pics or measurements on how much room you have with your dropped setup? Attached Images __________________ "Hey... its only time and money right? Just do it." 67 Short Bed under major construction http://67-72chevytrucks.com/vboard/s...=651356&page=8

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.