|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
01-10-2016, 07:45 PM
|
#1 |
|
Registered User
Join Date: Nov 2009
Location: Sonora California
Posts: 860
|
Another Pinion Angle question I'm back!
Well after a long battle with working on the house I'm back to working on the truck. I did a flip of the rear end and have new perches to be welded on. I have it set at about 6 degrees, pinion down. Several people have said 2, 3 or 4 degrees down is fine. How about 6? I just hate to loosen everything up again for a nats ass
Yey Ney or???????? I may just have I welded up as is and may shim or shave down the lowering block. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode